kurveygirl.com - Dzus, Vesrah, Brembo, Spring Clips and More
  Top » Catalog » Articles »

Guide: Installing Dzus Panex - Rivet Plates

by KurveyGirl

Dzus Panex Rivet-On Install Instructions
Install method: Dzus Panex Rivet-On
#
Description
Photo
1
Tools:

  • Stepped Drill Bit – OR – ¼” Drill Bit
  • 1/8” Drill Bit
  • 1/16” Drill Bit
  • Pop Rivet Tool
  • Measuring Tape

2
Check:
  1. Locate Rivet Plate on flat surface.
  • Rivet plates offer more mounting options than clip-on plates.


Picture #2
3
Drill Pilot Holes for rivet plates:
  • With clip located, use 1/16” drill bit to dill a pilot hole to accurately locate the two pop rivet holes.

picture 006
4
Drill Pilot Holes for Dzus bolt hole:
  • With clip located, use 1/16” drill bit to dill a pilot hole to accurately locate the Dzus bolt hole.

Picture 008
5
Use Backside center Dzus bolt hole to locate outer hole:
  1. Remove Clip
  2. Hold bodywork together
  3. Use the 1/16” Drill bit from backside and drill though front bodywork to locate the outer hole.

picture #010
6
Enlarge the rivet holes:
  • Use the stepped drill bit hole or a 1/8” Drill bit to enlarge the rivet holes on each side

Picture #012
7
Enlarge the Dzus bolt holes:
  1. Use the stepped drill bit hole for the bolt on both the inner and outer panel to ¼”.
  • Note: Can use a ¼” Drill bit in a pinch, but a stepped drill bit makes a cleaner hole.

picture #014
8
Mounting the Rivet Plate:
  1. Put a 1/8” Pop Rivet though the bodywork and rivet plate held on the inside.
  2. Squeeze the Pop Rivet tool to fasten the rivet plate to the bodywork.
Picture 16
9
Pop Rivets Appearance after mounting:
Picture #018
10
Install bolt:

  1. Install the bolt though the outer panel
  • Use a plastic washer on both the inside and outside to hold the bolt to the outer bodywork.  The inside washer will protect your paint from wear.
  1. Insert bolt though inner panel and turn bolt to engage.
  • It is normal to be difficult to turn the bolt the first time.
  • If the bolt seems “Loose”, you can add a second washer on the bolt to snug up the fit.
Picture #20

This article was published on Sunday 31 March, 2013.
Current Reviews: 0
Write Review
Tell a friend
Tell a friend about this article:  
0 items
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
Manufacturers
Authors